Tweco 51 with SL100SV CutMaster - Manual (Page 29)

Manual 0-4640 3-5 INSTALLATION
3
B. Installing Optional Single-Stage Air Filter
A Single-Stage filter kit is recommended for improved filtering, to keep moisture and debris out of the torch.
1. Attach the Single-Stage Filter Hose to the Inlet Port.
2. Attach the Filter Assembly to the filter hose.
3. Connect the air line to the Filter. Use only Synflex or equivalent grade hose. The illustration shows typical
fittings as an example.
NOTE
For a secure seal, apply thread sealant to the fitting threads, according to the maker's instructions. Do Not use
Teflon tape as a thread sealer, as small particles of the tape may break off and block the small air passages in the torch.
Connect as follows:
Art # A-03000
Regulator/Filter
Assembly
Inlet Port
Bowl
1/4 NPT Hose Fitting
1/4" (6 mm) Gas Supply Hose
Hose Clamp
Optional Single-Stage Filter Installation