10 automation interface pc board set-up, 10 automation interface pc board set-up -14 – Tweco CutMaster 101 with SL100SV User Manual
Page 38
INSTALLATION
3-14
Manual 0-4642
3
3.10 Automation Interface PC Board Set-up
The Automation Interface PC board includes switches that must be set to adapt the Interface Board to the automation system
being used.
NOTE
The switches are factory-set for the Thermal Dynamics SC-11 Standoff Control.
For operation with any other CNC equipment, refer to the CNC system documents to determine the division factor the CNC
system requires. Proceed as follows:
1.
Set the interface control board switches as indicated in the appropriate chart in the Appendix pages. The division factors
are listed in the right-hand column of each chart.
Automation
Interface
PC Board
Art # A-03902
Pilot PC
Board
Output Power
PC Board
Automation Interface PC Board
Art # A-03757
Switches
8 7 6 5 4 3 2 1
2.
Re-install the Power Supply cover.
- PAK 200i (160 pages)
- 211i Fabricator (96 pages)
- 15C Drag-Gun LT (32 pages)
- AirCut 15C (36 pages)
- TD-750 Cutting Systems (32 pages)
- TD-750 Cutting Systems (32 pages)
- 6000 Cutting System (36 pages)
- 100 Auto-Cut (104 pages)
- 100 Auto-Cut (148 pages)
- Auto-Cut 100 Torch Operation (20 pages)
- 200 Auto-Cut (136 pages)
- 300 Auto-Cut (164 pages)
- C-20A CUTSKILL (32 pages)
- C-35A CUTSKILL (36 pages)
- C-70A CUTSKILL (36 pages)
- 15XC CE Merlin PAK (134 pages)
- 6000 CE Merlin (78 pages)
- Merlin 6000 Plasma Cutting CE Slave Power Supply (48 pages)
- 6000GST Merlin Plasma Cutting CE Slave Power Supply (78 pages)
- 150XL CE PAK Master Without Latch Circuit (54 pages)
- CutMaster 101 (62 pages)
- CutMaster 10mm (66 pages)
- CutMaster 10mm-12mm (44 pages)
- CutMaster 12mm-20mm-25mm (80 pages)
- CutMaster 12mm (76 pages)
- 151 CutMaster (60 pages)
- 151 with SL100SV (172 pages)
- 152 CutMaster (84 pages)
- 15mm Cutmaster (44 pages)
- 20mm Cutmaster (80 pages)
- 25mm Cutmaster (80 pages)
- CutMaster 35mm 40mm (80 pages)
- CutMaster 35mm (84 pages)
- 38 CutMaster (54 pages)
- 38 CutMaster (51 pages)
- 39 CutMaster (68 pages)
- 42 CutMaster Operating Manual (35 pages)
- 42 CutMaster Service Manual (78 pages)
- 50 CutMaster (44 pages)
- 51 CutMaster (60 pages)
- 51 with SL100SV CutMaster (172 pages)
- 102 Cutmaster (80 pages)
- 82 PlazMaster (80 pages)
- 81 CutMaster (63 pages)