tekmar 553 Thermostat Installation - Manual (Page 23)

© 2014 553_D - 09/14
23 of 52 A Watts Water Technologies Company
Setting Display
FLOOR HIGH
The highest recorded floor temperature measurement.
Touch the number and the ENTER key to reset.
Access Level: Installer, User
Range: -76 to 149°F
(-60.0 to 65.0°C)
Conditions: Sensor 1 or 2 is set to FLOR. Default: Not applicable.
FLOOR LOW
The lowest recorded floor temperature measurement.
Touch the number and the ENTER key to reset.
Access Level: Installer, User
Range: -76 to 149°F
(-60.0 to 65.0°C)
Conditions: Sensor 1 or 2 is set to FLOR. Default: Not applicable.
FILTER HOURS
The total number of hours the fan has been operating
since the air filter was last replaced. Touch the number
and the ENTER key to reset and clear the Change
Filter warning message.
Access Level: Installer, User
Range: 0000 to 9999 hours
Conditions: Always available. Default: 0000 hours
HEAT Y HOURS
The total number of hours the heat pump has been
in heating operation. Touch the number and the
ENTER key to reset.
Access Level: Installer, User
Range: 0000 to 9999 hours
Conditions: Y RELAY is set to HP. Default: 0000 hours
HEAT W HOURS
The total number of hours the first stage heat W has
been operated for heating. Touch the number and
the ENTER key to reset.
Access Level: Installer, User
Range: 0000 to 9999 hours
Conditions: W TERM is set to HRF1, HRF2, CONV,
COIL, FURN , BKUP or OTHR.
Default: 0000 hours
HEAT W2 HOURS
The total number of hours the second stage heat
W2 has been operating. Touch the number and the
ENTER key to reset.
Access Level: Installer, User
Range: 0000 to 9999 hours
Conditions: ACC RELAY is set to W2. Default: 0000 hours
COOL Y HOURS
The total number of hours the air conditioner or
heat pump has been in cooling operation. Touch the
number and the ENTER key to reset.
Access Level: Installer, User
Range: 0000 to 9999 hours
Conditions: Y RELAY is set to AC or HP. Default: 0000 hours
Monitor Menu (3 of 4)