Powers 410 Series Pressure Balacing Mixing Valves - Manual (Page 2)

MAXIMUM TEMPERATURE SETTING
6. (Refer to Figure 5.) This must be set on the job. Mixer
will pass full HOT water. Loosen screw B (do not
remove). Rotate stem to get desired maximum temper-
ature. Move stop A until it touches stop C. Tighten
screw B.
Note: With high (over 140°F [60°C]) hot water, remove
screw B, turn stop A over as shown by dashed lines
(the word “HOT” will face in), replace screw B. Reset
stop A per above.
CAUTION. Adjustable stop A must be present for prop-
er installation. For further information on repair and
maintenance, see Technical Instruction.
II410 Page 2
Figure 3.
Figure 4.
Figure 5.
Reprinted © May 2001 Powers, a Watts Industries Co.
3400 Oakton Street, Skokie, IL 60076 Phone: 800.669.5430 • 847.673.6700 • Fax: 847.673.9044
www.powerscontrols.com
5435 North Service Road, Burlington, Ontario, L7L 5H7 Canada • Phone: 888.208.8927 • Fax: 888.882.1979 A Watts Industries Co.
WARRANTY INFORMATION
Powers warrants that the equipment manufactured by it is free from defects in material and workmanship and, without charge, equipment
found to be defective in material and workmanship will be repaired, or at Seller’s option, replaced F.O.B. original point of shipment, if writ-
ten notice of failure is received by Seller within one (1) year after date of shipment, provided said equipment has been properly installed,
operated in accordance with Seller’s instructions, and provided such defects are not due to abuse or chemical decomposition by chemical
or galvanic action. This express warranty is in lieu of and excludes all other warranties, guarantees, or representations, express or implied.
There are no implied warranties for merchantability or of fitness for a particular purpose. The Seller assumes no responsibility for repairs
made on Seller’s equipment unless done by Seller’s authorized personnel, or by written authority from the Seller. The Seller makes no guar-
antee with respect to material not manufactured by it.
Form II410 0218 EDP# 6512218 Printed in U.S.A.