Photoflex AC-DUALSMKT DualFlash Adapter Kit - Manual (Page 2)

2
AC-DUALSM
photoflex lightingschool .com
steps in assembly with
an umbrella
1. Installing the upper and lower Umbrella mounting shaft
2. Installing the heavy duty swivel stand mount
3. Installing an umbrella
4. Installing Shoe mount flash units
5. Installing a wireless receiver
Parts List
Before assembling your Dual Flash Hardware, make sure all
components are present (note: for umbrella applications you
will not use the male & female brass studs)
You should have:
T shaped Plate – qty 1
Cold shoe mounts – qty 4
Upper umbrella shaft with set screw– qty 1
Lower umbrella shaft – qty 1
Male brass stud – qty 1
Female brass stud – qty 1
Heavy duty aluminum swivel stand mount – qty 1
1. installing the upper
and lower umbrella
mounting shaft
The T shaped plate has a 3/8” hole in it; insert the lower
umbrella shaft through the hole [Fig 1]
The upper umbrella shaft has a 3/8” female tapped base that
will allow it to screw onto the male end of the lower umbrel-
la shaft. Hand tighten them together making sure that the
umbrella mounting hole at the top of the upper shaft is posi-
tioned so that when the umbrella is assembled to it the flash
units will face the umbrella. [Fig 2]
A screwdriver may be used to provide additional leverage in
tightening the upper and lower shaft together. [Fig 3]
Figure 1.
Figure 2.
Figure 3.