Photoflex ST-MD LiteRoom: medium - Manual

visit photoflex lightingschool .com® for the best free learning resource! For detailed specifications, product tutorials and more, please visit www.photoflex.com®
PROFESSIONAL PHOTOGEAR
LiteRoom Instruction Manual • Item#: ST-MD Rev LiteRoom 6/19/12
LiteRoom
Before assembling your LiteRoom, make sure all components are
present. You will need:
• LiteRoom fabric tent with connector
• Four rods
Assemble the LiteRoom Softbox to the Connector
1. Place the LiteRoom with all four rods into their sleeves on
a flat, clean surface.
2. If closed, open all four Quick Release Corners (QRC). Pull
Velcro ® tab open at each corner so that rods extend freely.
3. Position connector at the center of the softbox. Insert the
first rod into one of the rod receptacle holes.
4. Insert the second rod into the hole diagonally opposite
the first hole. Insert the third and fourth rods in the same
fashion.
5. Use one hand to pull QRC flap over rod tip while pushing
the rod into place with your thumb. Secure flap to its
Velcro ® counterpart. Repeat this process for the remaining
corners..
NOTE: For proper dome shape to be achieved all rods must
be pushed in completely.
Shooting Ports
6. The top of the LiteRoom has a cover flap which can be
opened to expose an overhead shooting port. When not in
use, simply secure the Velcro ® to its counterpart.
7. The front of the LiteRoom can be zipped completely open
to provide complete access to the interior.
8. The vertical zipper in the center of the front of the
LiteRoom has a double zipper design so that an opening
can be created around the camera lens at any position.
9. For optimal super soft product lighting use one or two
external lights with softboxes.
Figure 2. Figure 1.
Figure 3.
Figure 6.
Figure 8.
Figure 4.
Figure 5.
Figure 7.
Figure 9.
PHOTOFLEX ® WARRANTY
• Warranties only cover manufacturer’s defects and workmanship
• We reserve the right to inspect all merchandise returned (end users
and dealers) for warranty fulfillment.
• All returns must be accompanied by a receipt showing date of
purchase.
• Freight must be paid by the customer or dealer.
• Warranties are valid only from date of Original Purchase.
Customer Support (800) 486-2674
email: [email protected]
Corporate Office (831) 786-1370 • FAX (831) 786-1372
97 Hangar Way, Watsonville, CA 95076