Photoflex FV-XT2MLDKIT Medium LiteDome Deluxe Kit User Manual

Medium litedome, Deluxe kit

Visit photoflex

lightingschool

.com® for the best free learning resource!

For detailed specifications,

product tutorial videos

and more, please visit

www.photoflex

.com

PROFESSIONAL PHOTOGEAR

Medium LiteDome

Deluxe Kit Instruction Manual • Item #: FV-XT2MLDKIT

Medium LiteDome

Deluxe Kit

Before assembling your Small LiteDome

, make sure all

components are present. You will need:

• Medium LiteDome

Softbox (A)

• BasicConnector (B)

• Adjustable ShoeMount Hardware (C)

• Aluminum Swivel (D)

• Medium LiteStand (E)

Attach Adjustable ShoeMount to the BasicConnector

1. Use the smaller threaded end (1/4”-20) of the reversible

stud to attach the ShoeMount hardware to the brass

threaded hole in the BasicConnector (Fig. 1). There

is a guide pin at the top of the bracket which lines up with

the untapped holes adjacent to the brass threaded hole

for added stability (the guide pin is removable for use with

other connectors that don’t have guide holes).

2. A screwdriver can be inserted into the pass hole in the

stud to assist in tightening the ShoeMount hardware.

A wrench can also be used on the flat surfaces of the stud.

The ShoeMount hardware should extend out from the side

(Fig. 2).

Attach LiteDome Softbox to the BasicConnector

3. The softbox includes four rods. The rods should already

be inserted into the interior sleeves of the softbox (Fig. 3).

We recommend leaving the rods in the sleeves during

storage. It is normal for them to develop a slight bend

where they attach to the BasicConnector.

4. If closed, open all four Quick Release Corners (QRC).

Pull the Velcro

tab open at each corner so the rods

extend freely (Fig. 4).

5. Each of the rods will fit in a corner hole of the

BasicConnector (Fig. 5). Be sure each rod seats all the

way into its connector hole. Start with any hole, then

connect the rod directly opposite the starting rod (Fig. 6).

Then insert the rest of the rods (Fig. 6a).

6. After the rods are inserted into the connector, secure the

QRC Velcro® corners. Use one hand to pull the QRC flap

over the rod tip while pushing the rod into place with your

thumb (Fig. 7). Secure the flap to its Velcro® counterpart.

Repeat this process for each of the corners (Fig. 8).

Figure 1.

Figure 4.

Figure 2.

Figure 3.

Figure 5.

Figure 6.

Rev 12/12/12

Stud

Figure 7.

Figure 8.

Figure 6a.