Photoflex FV-XT1SLDKIT Small LiteDome Deluxe Kit - Manual

Visit photoflex lightingschool .com® for the best free learning resource! For detailed specifications, product tutorial videos and more, please visit www.photoflex ® .com
PROFESSIONAL PHOTOGEAR
Small LiteDome ® Deluxe Kit Instruction Manual • Item #: FV-XT1SLDKIT
Small LiteDome ® Deluxe Kit
Before assembling your Small LiteDome ® , make sure all
components are present. You will need:
• Small LiteDome ® Softbox (A)
• Basic Connector (B)
• Adjustable ShoeMount Hardware (C)
• ShoeMount MultiClamp (D)
• Medium LiteStand (E)
Attach Adjustable ShoeMount to the BasicConnector
1. Use the smaller threaded end (1/4”-20) of the reversible
stud to attach the ShoeMount Hardware to the brass
threaded hole in the BasicConnector (Fig. 1). There
is a guide pin at the top of the bracket which lines up with
the untapped holes adjacent to the brass threaded hole
for added stability (the guide pin is removable for use with
other connectors that don’t have guide holes).
2. A screwdriver can be inserted into the pass hole in the
stud to assist in tightening the ShoeMount hardware.
A wrench can also be used on the flat surfaces of the stud.
The ShoeMount hardware should extend out from the side
(Fig. 2).
Attach LiteDome SoftBox to the BasicConnector
3. The softbox includes four rods. The rods should already
be inserted into the interior sleeves of the softbox (Fig. 3).
We recommend leaving the rods in the sleeves during
storage. It is normal for them to develop a slight bend
where they attach to the BasicConnector.
4. Each of the rods will fit in a corner hole of the
BasicConnector (Fig. 4). Be sure each rod seats all the
way into its connector hole. Start with any hole, then
connect the rod directly opposite the starting rod (Fig. 5).
Then insert the rest of the rods (Fig. 6).
5. After all rods are inserted, with the softbox on the floor,
push down at each corner point to be sure each rod is
all the way into its connection hole (Fig. 7). Tip: For
disassembly, use this same technique of pushing down on
the rod corner to make it easier to remove the rod.
6. The flaps of the softbox near the connector ring can be
connected at the corners using the Velcro ® sewn into the
flaps (Fig. 8).
7. The softbox can be changed to a vertical or horizontal
position on the connector ring by removing the rods from
the connector & reassembling after a 90 degree rotation.
Figure 1.
Figure 4.
Figure 2.
Figure 3.
Figure 5. Figure 6.
Rev 12/12/12
A B
D E
C
Pin
Stud
Figure 8. Figure 7.