Nipros LS-800 Operating Instruction - Manual (Page 45)

45
Adjustments and Settings for LS-800
1 PGM AUDIO input signal adjustment and Setting
LINE LINE
MIC MIC MIC
CA AUDIO
1
PGM AUDIO IN
OFF
ON
1kHz
LMT MIC LMT
２
１
ST
CA
PGM
MONI
OUT
MONI.VOL
PGM INPUT
MONI
OVER OVER OVER OVER
CABLE
CONNECTOR
CA AUDIO
2
(front panel)
headphone
LANC TALLY
OPT
HD/SDI OUT 1
IN OUT
HD-Y/VIDEO
OUT
HD/SDI IN1 HD/SDI
RET
1 2 1 2
AUDIO IN
CA
AUDIO OUT
PGM
from
switcher,
audio mixer,
etc.
Select the monitor audio channel by the select switch, 1, 2 or 1/2stereo.
Adjust the headphone audio level by the MONI. VOL volume control.
During adjustment, set the LIMIT switch to the OFF position.
Accordig to the input signal, set to the ON position to prevent the audio distortion
by a sudden high level audio input.
Set the AUDIO IN LIMITER switch to the on or off position.
To monitor the PGM INPUT audio signal by a headphone
set the MONI CA/PGM select switch to the PGM position.
Select the PGM AUDIO IN 1/2 MIC/LINE select switch to the appropriate position
according to the input signal to the PGM AUDIO IN 1/2 connectors.
Adjust the audio input level by the PGM AUDIO IN 1/2 volume
so that the input level become to the proper level while watching the PGM INPUT audio level meter.
Input the audio output signal from an audio source to the PGM AUDIO IN 1/2 connectors.
LINE LINE OFF OFF
Adjustments and Settings
Turn on the power switches of LS-700, LS-800, Monitor and Camera.
Make sure the volume of each unit is set to the minimum position before starting adjustment.
Never turn up the volumes suddenly to prevent hearing impairment.
PGM audio signal
(rear panel)
LS-800
Optical Fiber Camera Adaptor LS-700/Optical Fiber Base Station LS-800 LS-700/LS-800