Nipros LS-800 Operating Instruction - Manual (Page 42)

Adjustments and Settings
42
Turn on the power switches of LS-700, LS-800, Monitor and Camera.
Make sure the volume of each unit is set to the minimum position before starting adjustment.
Never turn up the volumes suddenly to prevent hearing impairment.
During adjustment, set the LIMIT switch to the OFF position.
Accordig to the input signal, set to the ON position to prevent the audio distortion
by a sudden high level audio input.
Adjustments and Settings for LS-700
Audio input signal adjustment and setting
Select the AUDIO IN 1/2 LINE/MIC/P48 select switch to the appropriate position
according to the input signal to the AUDIO IN 1/2 connector.
Adjust the audio input level by the AUDIO IN LEVEL 1/2 volume so that the input level
become to the proper level while watching the audio level meter.
To monitor the audio input signal by a headphone
select the monitor channel 1, 2, or 1/2stereo by the select switch.
Adjust the headphone audio level by trhe AUDIO MONITOR LEVEL volume.
Select AUDIO IN LIMITER ON/OFF switch.
1
Input the audio output signal from an audio source to the AUDIO IN 1/2 connectors.
PRONPTER/
REF.VIDEO
OUT
RET1/2
HD-Y/
VIDEO
OUT
HD-Y/
VIDEO
IN
LINE
P48
MIC
LINE
MIC
LINE
MIC
AUDIO
IN 1
LINE
P４８
MIC
AUDIO
IN 2
PGM AUDIO
OUT 1
PGM AUDIO
OUT 2
TALLY
OUT
REMOTE
IN
G U O
HEADPHONE
AUDIO signal
LINE
P48
MIC
LINE : +4dB
MIC : -60dB
P48 : -60dB,
DC 48V power
(rear panel)
(main panel)
from
camcorder,
microphone,
etc.
AUDIO
IN 1/2
(XLR 3-pin)
AUDIO IN 1/2 select switch
Optical Fiber Camera Adaptor LS-700/Optical Fiber Base Station LS-800 LS-700/LS-800
H.P
INCOM
1
2
1 2
AUDIO IN
MONITOR
LEVEL
AUDIO IN
LEVEL
AUDIO IN
1 2
OFF
ON
ON
AUDIO IN
LIMITER
OFF OVER OVER
HD-SDI
REMOTE
REF
RET
SYSTEM
TALLY
ON
POWER
OFF
HEADSET1 ▶
HEADSET2 ▶
OPTICAL FIBER CAMERA ADAPTOR
TALLY
INCOM
PGM
TALK
ENG
PROD
PGM PGM PGM
RET
2
1
OFF
ON
2 1
3 2
1kHz
OFF
ON
1/2
TALK
ENG
PROD
2
1
OFF
ON
1 2
TC
SIDE TONE