E-flite Deuces Wild 25e2 ARF - Manual (Page 7)

7 E-flite Deuces Wild Assembly Manual
 6. Repeat all of the previous steps to install the rudder
servo and steering servo in the fuselage. Note that the
steering servo is in the center location when installed.
Please note the orientation of the servos in the fuselage.
 7. Use hook and loop tape to install the receiver into the
fuselage. When installing a remote receiver, place it as
far away from the main receiver as possible, aligning the
antennas perpendicular to those of the main receiver.
Note: If you are using a standard 72MHz receiver, an
antenna tube has been installed in the fuselage to route
the antenna wire to the rear of the fuselage. Never cut
the receiver antenna as this will greatly reduce the range
of your radio system.