E-flite Deuces Wild 25e2 ARF - Manual (Page 57)

57 E-flite Deuces Wild Assembly Manual
 3. With the outer wing panel tight against the wing
center section, use a 3/32-inch ball driver to install the
4-40 x 1-inch socket head bolt that secures the outer
panel to the center section. Complete for the opposite
wing panel.
 4. Position the wing on the fuselage. Use two 1/4-20 x
2-inch nylon bolts and a flat screwdriver to secure the
wing to the fuselage. Ensure you connect the air lines as
well as the servo wires from the wing into the respective
ports on the receiver before fully installing the wing.
Canopy and Gear Door Installation
Required Parts
Fuselage assembly Canopy
Tie wrap (4) Main gear door (right and left)
Required Tools and Adhesives
Low-tack tape Canopy glue
Side cutters Drill
Drill bit: 5/64-inch (2mm)
Silicone adhesive
Note: You may wish to install the optional cockpit kit at
this time. Instructions have been provided with that kit on
how to install it into your Deuces Wild.
 1. Use canopy glue to attach the canopy to the fuselage.
Use low-tack tape to hold the canopy in position until the
glue has fully cured.