E-flite Deuces Wild 25e2 ARF - Manual (Page 22)

22 E-flite Deuces Wild Assembly Manual
 4. Secure the flap servo in the wing using a #1 Phillips
screwdriver and the hardware provided with the servo.
 5. Thread the nylon control horns onto the flap torque
rods until they are flush on top. Make sure they are
positioned equally or the flaps will not have the same
amount of throw.
 6. Remove the flap servo horn from the flap servo. Use a
pin drill and 5/64-inch (2mm) drill bit to enlarge to outer
hole of the flap servo horn.
 7. Slide the brass pushrod connector in the hole drilled in
the previous step.