E-flite Deuces Wild 25e2 ARF - Manual (Page 55)

55 E-flite Deuces Wild Assembly Manual
Note: Use paper towels and rubbing alcohol to clean up
any excess epoxy that squeezes out from the nacelles
onto the wing in this step.
 8. Once the epoxy has fully cured, use canopy glue to
glue the aft edges of the nacelle to the wing top and
bottom wing covering. The covering does not need to be
removed from the wing for this. Use low-tack tape to hold
the nacelle tight against the wing while the canopy glue
cures.
 9. If using the E-flite 60 Amp ESC, you only need one
of the BEC's to be active. To disarm the BEC on one of
the ESC's, you will need to remove the red wire from the
servo plug on the ESC. Tape this wire back on itself once
completed. Now connect the lead from the ESC to the
previously installed extension lead. Ensure you use some
dental floss or a commercially available device to secure
the connection.
 10. Repeat Steps 1 through 9 to install the remaining
propeller, spinner and ESC.