E-flite Deuces Wild 25e2 ARF - Manual (Page 23)

23 E-flite Deuces Wild Assembly Manual
 8. Secure the connector using a nylon connector
backplate. You may trim the servo horn with side cutters
to remove the unused arms if you choose.
 9. Install the servo horn on the flap servo. The horn is
shown installed in the up flap position.
 10. Slide a silicone clevis retainer onto each of the two
clevises required for the flap linkage. Thread the clevises
onto the flap linkage.
 11. Attach the clevises to the flap control horns. The
wire will then slide into the brass pushrod connector
on the servo. You may need to use pliers to make a
slight bend in the linkage so it will not bind when the
flaps are in operation.