E-flite Deuces Wild 25e2 ARF - Manual (Page 15)

15 E-flite Deuces Wild Assembly Manual
 16. Slide the pushrod keeper onto the wire. Position the
wire so the bend in the wire is snug against the control
horn as shown.
 17. The notch in the pushrod keeper will snap onto the
pushrod wire. This will keep the pushrod secure. You
may need to use pliers to apply enough force to snap the
pushrod keeper onto the wire.
 18. Use side cutters to remove any excess wire that
extends beyond the connector. Leave a small amount of
wire to prevent the keeper from popping off accidentally.
 19. Remove the pushrod keeper and rotate the pushrod
180 degrees. Insert the pushrod into the nylon control
horn and reinstall the pushrod keeper. This is necessary
so the keeper doesn't bind against the fuselage during
the operation of the rudder.