E-flite Deuces Wild 25e2 ARF - Manual (Page 58)

58 E-flite Deuces Wild Assembly Manual
 2. Fill the retract system with a commercially available air
pump and operate the retracts. With the main gear in the
UP position, apply a bead of silicone adhesive to the strut
wire and tape the gear cover in position on the wing. Set
the wing aside and allow the adhesive to fully cure.
 3. Once cured, drill a 5/64-inch (2mm) hole on each
side of the wire struts for the tie wraps to go through.
Drill the holes as close to the top and bottom of the cover
as possible.
 4. Use a tie wrap near the top and bottom of the gear
cover to complete their installation. Use side cutters to
trim the excess to prevent the tie wraps from interfering
with the wheel or operation of the retracts.
Note: It is easier to remove the wheel then install the
tie wrap near the wheel. Always remember to use
threadlock on metal-to-metal fasteners to prevent them
from vibrating loose.
 5. Repeat Steps 2 through 4 to install the remaining
gear cover.