Brandmotion 9002-8521 - Manual (Page 3)

"#$%&''&%"(# "#$%)*+%"(#$
8521 Instructions 7-26-13.doc Page 3 of 5
Step 9: Align the Camera Harness head so the key
lines up with the slot in the camera, and plug in the
connector. Snug the supplied screws with a Phillips
Screwdriver to create a watertight seal but do not
over tighten.
Step 10: Mount the Camera using the supplied
hardware. Insert the two Rubber Well Nuts into the
outer 5/16” camera mount holes.
Step 11: Thread the two supplied Bolts through
the Camera Mount and into the Well Nuts using a
Phillips Screwdriver but do not tighten the Bolts all
the way down just yet.
Step 12: Remove vehicle mirror.
CAUTION: Removing the mirror can cause
damage to the windshield.
Step 13: Attach supplied Mirror to the windshield
using a T20 Torx Driver. This mirror has a Wedge/
D-tab style mounting base. Please check our
compatibility chart to make sure it is compatible
with your vehicle (adapters are available for
specific applications separately).
IMPORTANT: Torque for the mirror screw that
attaches to the windshield tab is 1.8 Nm (16
lb-in) and cannot exceed 2.2 Nm (19.5 lb-in).
Step 14: Determine location of vehicle Ignition
power and Ground. Using a vehicle specific service
guide/wiring diagram and a Digital Multi-Meter or
Computer-Safe Test Light, locate which side of the
vehicle contains the wires into which you will
connect Mirror Harness wiring (see chart below).
(Follow Steps 15-17 only if your vehicle is
equipped with Exterior Auto Dimming
Mirrors. Otherwise, proceed to Step 18).
Step 15: Located on the bottom side of the 16-pin
mirror connector is a rectangular white bar called a
Terminal Position Assurance (TPA) tab. Use Delphi
Terminal Tool 12094429 or a Small Flatblade Watch
Repair Screwdriver to release the TPA as shown.
The TPA will only lift about 1/10 th of an inch.
Step 16: Insert supplied Orange lead into 16-pin
connector cavity 5 and White lead into 16-pin
connector cavity 16 until they click into place. If
they do not seat initially, use Delphi Terminal Tool
12094429 or a small flatblade watch repair
screwdriver to press the terminals fully into the
connector. Next, press down on the TPA to lock the
terminals.
Mirror Harness Pinout
PIN
WIRE
COLOR FUNCTION
1 - 4 N/A N/A
*5 Orange Exterior Auto Dimming (+)
6 White Video +
7 Brown Video -
8 Black Ground
9 Green Reverse Signal 12V+
10 - 12 N/A N/A
13 Red Ignition Controlled 12V+
14 - 15 N/A N/A
*16 White Exterior Auto Dimming (–)
CAUTION:
Once correct wires have been identified, turn
Ignition key OFF and DO NOT TURN key back ON
until the install has been completed (Step 25).
White dot
identifies
cavity 1