Bang & Olufsen BeoVision Avant (1995-2005) - User Guide - Manual (Page 69)

69
… O P E R A T I O N
Buttons on the BeoVision Avant operation panel
• PLAY TIMER TV SAT V.TAPE EJECT REWIND BeoVision Avant operation panel – The
buttons are placed on the rear side of the display
bar, but you will find that they are easily operated
when you are standing in front of the BeoVision
Avant.
EJECT
Unloads the video cassette you have loaded into
the video tape recorder.
REWIND
Rewinds the tape in the video tape recorder
quickly to the beginning.
V.TAPE
Starts playback of the tape in the video tape
recorder. Press V.TAPE for more than three
seconds, and the video tape recorder switches off
immediately, stopping any function in progress.
SAT
The SAT button enables you to switch on to
satellite TV, and to step through your satellite TV
program numbers.
TV
The TV button enables you to switch on the TV,
and to step through your TV program numbers.
PLAY TIMER
Switches on the BeoVision Avant timer function,
which ensures that any timer play instruction you
have programmed into the system will be
executed with the BeoVision Avant picture screen
and/or speakers cut in.
•
Switches the BeoVision Avant to standby.
Sockets for Headphones and CamCorder
PHONES – Headphones
You can connect stereo headphones to the socket
marked PHONES. The BeoVision Avant
loudspeakers can then be cut out by pressing the
Beo4 volume button on the middle.
L, R, VIDEO, S-VHS – CamCorder
The sockets marked L, R, VIDEO, and S-VHS are for
connection of a video camera:
L R sockets...
for audio connection (left and
right respectively).
VIDEO socket... for the video signal.
S-VHS socket... for the connection of S-VHS or
Hi-8 camcorders only.
To watch your CamCorder recordings on the
BeoVision Avant, connect the camera and switch
the BeoVision Avant on by pressing, e.g the TV
button on the Beo4 remote control. Then, when
you start playback on your camera, the BeoVision
Avant automatically registers the signal and you
can see the pictures from the CamCorder on the
screen.
Note: If the signal from the CamCorder is switched
off (accidentally), you must find CAMCORD* in the
Beo4 display and press GO.
*Note: In order to find CAMCORD in the Beo4
display you have to add the function, see page 67
for further instruction.
PHONES R L VIDEO S–VHS
BeoVision Avant easy-access socket panel
Just below the operation panel on the back of
BeoVision Avant, a small socket panel is con-
veniently placed for connection of headphones
and CamCorder. Please note: The other sockets
are hidden behind a cover which you must
remove before you can connect any equipment to
these three sockets.