Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 35)

Publication DNET-UM003A-EN-P - August 2000
Construct Your Starter Kit 2-13
.
At this point, your network should look like this:
IMPORTANT
You will set the node address and place the top of the
ArmorBlock MaXum I/O onto the seal block when you
commission the node in Chapter 3.
ATTENTION
!
Be certain that all screws and end caps are securely
tightened to properly seal the base against leaks and
maintain IP67 requirements.
41533
Match arrows
so the seal
block is in the
correct
position over
the cable
base.
When the
lines of the
seal block
meet the
base it is
fully seated.
Seal Block
Base
0 1 2 3 4
5 8 9 7
0 1 2 3 4
5 8 9 7 6
6
42166