Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 27)

Publication DNET-UM003A-EN-P - August 2000
Construct Your Starter Kit 2-5
The KwikLink taps are also called Insulation Displacement Connectors
(IDC). Follow these steps attach the KwikLink taps (IDC) to the flat
KwikLink cable:
1. Lay the cable in the hinged base. Pay attention to the keyed
profile. The unkeyed edge is closer to the hinge; the keyed edge
is toward the latch.
I-0
A-0
I-1
A-1
O-0
O-1
Auxiliary Power
Network Status Module Status
KwikLink Termination
Resistor and end cap
KwikLink Taps (IDC)
ArmorBlock MaXum I/O
KwikLink Tap (IDC)
Termination
Resistor and
end cap
KwikLink open-style tap
connected to your power supply
Node 01
Standard Proximity
Switch connected
to Input 1
Node 02
Compact
Block I/O Node 03
ControlTower
Stack Light Node 04
Inductive
Proximity
Switch Node 05
RightSight
Photoelectronic
Sensor
42079
Node 00
Scanners: 1756-DNB
1747-SDN
1771-SDN
1784-PCIDS
IMPORTANT
Prior to closing the connector, be certain that the IDC
blades do not protrude from the housing. If the blades are
exposed, gently push them back into the base. In the
event that the blades do not retract easily (or retract only
partially), verify that the IDC screws are not partially
driven.
30474
Keyed edge is
toward the latch
latch