Rockwell Automation T8094 8000 Series TMR System Safety Manual - Manual (Page 23)

SAFETY MANUAL
D oc N umber T8094
I ssue 27 – June 2013
Page 2 of 103
1.2 ASSOCIATED DOCUMENTS
The following documents are associated with the safety requirements applicable to the
TMR system or provide supporting information via TUV web Site.
Document Title
"Maintenance Override" by TÜV
Süddeutschland / TÜV Product Service
GmbH and TÜV Rheinland
IEC61508 Functional Safety of Programmable
Electronic Systems
IEC61511 Functional safety: Safety Instrumented
Systems for the process industry sector
EN54-2 Fire Detection and Fire Alarm Systems
NFPA 72:2007 National Fire Alarm Code
NFPA 85:2007 Boiler and Combustion Systems Hazards
Code
NFPA 86:2007 Standard for Ovens and Furnaces
Table 1 - Referenced documents
An understanding of basic safety and functional safety principles and the content of
these standards in particular are highly recommended. The principles of these
standards should be thoroughly understood before generating procedures and
practises to meet the requirements of this Safety Manual.
1.3 TERMINOLOGY
The terms ‘certification’ and ‘certified’ are used widely within this Manual. Within the
context of this Manual, these terms refer to the functional safety certification of the
product to IEC 61508 SIL 3. The 8000 series as a product is certified to a wider range
of standards that are outside the scope of this Safety Manual.
This Manual contains rules and recommendations:
Rules are mandatory and must be followed if the resulting system is to be a SIL 3
compliant application. These are identified by terms such as ‘shall’.
Recommendations are not mandatory, but if they are not followed, extra safety
precautions must be taken in order to certify the system. Recommendations are
identified by terms such as `it is strongly recommended’.