Rockwell Automation 6185-F RAC6185 Industrial Flat Panel Monitors User Manual - Manual (Page 35)

1 Publication 6185-UM006A-EN-P - July 2002
Chapter
4
Performing Routine Maintenance
Chapter Objective This section describes cleaning the RAC6185 Industrial Flat Panel Monitor
(6185-F), and performing other routine maintenance.
Cleaning Occasionally clean the display panel and cabinet with a soft cloth dampened
(not soaked) with a mild (non-abrasive) glass cleaner. Keep turning a fresh side
of the cloth toward the screen surface to avoid scratching it with accumulated
grit.
Special care should be taken when cleaning a touchscreen or polycarbonate
shield that is installed over the screen. Abrasive and certain chemical cleaners
can easily damage the surface.
Replacing a Line Cord To avoid shock and fire hazards, the monitor’s power cord should be replaced
if the insulation becomes broken or if it develops a loose internal connection.
Contact your authorized Allen-Bradley distributor for ordering information.
Other Maintenance Qualified service personnel should perform all maintenance, except for the
power cord replacement described above. Contact Allen-Bradley Technical
Support for assistance (Refer to Allen-Bradley Support on page P-3).
IMPORTANT
The solvent should be applied only to the cloth, and not
directly on the monitor screen. Do not use paper products
as they may scratch the surface. To minimize the risk of
abrasion, allow the screen to stand dry.
ATTENTION
!
You can use alcoholic or ammoniac cleaners to clean the
polycarbonate shield or a touchscreen. However, use only
one or the other at all times. A residue mixture can cause a
chemical reaction.