Rockwell Automation 6185-F RAC6185 Industrial Flat Panel Monitors User Manual - Manual (Page 30)

Publication 6185-UM006A-EN-P - July 2002
3-8 Configuring the Video Setup
Table 3.D OSD Menus and Adjustment Instructions
Option Menu How To Adjust
Brightness Use the Brightness control to adjust the overall intensity of the
monitor.
1. Push the Menu button to open the OSD. Brightness
adjustment is the first function available in the OSD.
2. Push the Menu button to open the Brightness adjustment
screen.
3. Use the + button to increase brightness, and the - button to
decrease brightness.
When the OSD is not activated, you can access Brightness control
directly by pushing the + or - button to adjust brightness.
Contrast Use the Contrast control to adjust the difference between the
monitor’s light and dark elements.
1. Push the Menu button to open the OSD.
2. Push the + and - button until the Contrast screen is
displayed.
3. Push the Menu button to open the Contrast adjustment
screen.
4. Use the + button to increase contrast, and the - button to
decrease contrast.
Image Lock:
Coarse Image Lock limits the amount of noise in the video signal that
causes the image to be unstable or jittery.
Begin adjusting your image using the Coarse adjustment. The
Coarse adjustment controls the video sample rate and affects the
horizontal size of the image.
If you cannot obtain satisfactory results with Coarse adjustment
alone, then use the Fine adjustment.
1. Push the Menu button to open the OSD.
2. Push the + and - button until the Image Lock screen is
displayed.
3. Push the Menu button again, and then press the + or -
button until the Coarse adjustment is selected.
4. Push the Menu button to open the Coarse adjustment
screen.
5. Use the + and - buttons to manipulate the Coarse
adjustment and remove image noise.
If you are running a non-native resolution on your monitor,
then the left border of the ScreenSet setup screen should be as far
left as possible while still being visible before you perform a Coarse
adjustment. If it is not, adjust Horizontal Position until it is. Then
adjust the Coarse setting until the right side border is as far right as
possible while still being visible.