Rockwell Automation 6185-F RAC6185 Industrial Flat Panel Monitors User Manual - Manual (Page 18)

Publication 6185-UM006A-EN-P - July 2002
2-8 Installation
Installing Your Monitor
in a Rack Using optional rack adapters, you can install the RAC6185 Industrial Flat Panel
Monitor (6185-F) into a rack. The rack adapter option for the 6185-F is
Accessory option R. For rack adapter installation procedures, see Appendix A,
Installing Rack Brackets on the RAC6185 Industrial Flat Panel Monitor
(6185-F) on page A-1.
Tools Needed for Rack Mount Installation
You will need the following tools:
• EIA panel mounting hardware
• Phillips screwdriver (medium)
Rack Mounting Guidelines
Observe the following precautions when installing this unit in a rack:
• The cabinet must be tall enough to accommodate the monitor’s panel
height:
– eight rack units, 14.00 in (356 mm)
• The cabinet must be deep enough to accommodate the monitor’s depth
while providing rear clearance for cabling and airflow. The following
cabinet depths are sufficient:
– 2.9 in (74 mm)
• No slides or shelves are required because the rack mount monitor is
designed to be supported by the panels in which it is installed.