Rockwell Automation 7000 PowerFlex HMI Offering with Enhanced Functionality - Manual (Page 49)

Rockwell Automation Publication 7000-UM201B-EN-P - June 2013 47
Drive Terminal Application Chapter 4
Enable or Disable Fault Masks
The drive contains numerous fault masks which enable or disable whether that
particular fault occurs.
The screen typical of Figure 44 contains two panels. The left shows the faults
which are enabled and the right panel shows the faults which are disabled.
Clicking on the column headers sorts the list by either standard drive ordering or
alphabetically.
To change the status of a particular fault:
1. Select the fault you wish to enable or disable.
2. Press the arrow (----> or <----) key to move the fault to the other state.
Figure 44 - Masks Setup
TIP To move all the masks to the other state, select a fault in the group and press
‘All’.