Rockwell Automation 61C542 Voltage Input module - Manual (Page 16)

3Ć4
Step 8. Connect the programming terminal to the system and run
the ReSource Programming Executive Software.
Stop all programs that may be running.
Configure the voltage input channels you are using by
following the procedure in section 4.2. You cannot monitor
the registers on the module until you have configured the
channels. When you are done configuring, read the
channels' default values to verify that the installation is
correct. Refer to sections 4.1.1 to 4.1.17 for the default
values.
ЙЙЙ
ЙЙЙ
ЙЙ
OA
S
1A
OB
S
1B
Field Wiring
Voltage
Transmitter
(SingleĆ
Ended)
Terminal Board
(M/N 61C547 or M/N 61C548)
-
+
Voltage
Transmitter
(SingleĆ
Ended)
-
+
ЙЙЙ
ЙЙЙ
ЙЙ
13A
14A
S
13B
14B
S
-
+
-
+
S
12B
15A
15B
Voltage
Transmitter
(Differential)
Voltage
Transmitter
(Differential)
S
(1) All A" terminals ( 4 AĆ15A are tied to the
analog common bus.
(2) All analog inputs must be within +10V of
analog common for proper operation.
Notes:
Figure 3.3 Ć Transmitter Wiring Connections