Rockwell Automation 61C346 4 Input 0-10V Analog Rail Module - Manual (Page 18)

3Ć4
Step 9. Using 14Ć22AWG wire, connect external hardware to the
Analog Inputs" plug connector on the faceplate as shown
below. Strip off approximately 5/16" insulation from the
wires.
Channel
Terminal
Number
Terminal
Label Signal
0 1
2
3
VĆIN
Common
(no label)
0Ć10V+ input
common
(shield; no connection)*
1 4
5
6
VĆIN
Common
(no label)
0Ć10V+ input
common
(shield; no connection)*
2 7
8
9
VĆIN
Common
(no label)
0Ć10V+ input
common
(shield; no connection)*
3 10
11
12
VĆIN
Common
(no label)
0Ć10V+ input
common
(shield; no connection)*
* This pin makes no electrical connection to the Analog Rail printed circuit
board.
Step 10. For the four input channels, connect a shield wire from the
external hardware to the third terminal (terminals 3, 6, 9
and 12, respectively) on each channel. The shield wire at
the external hardware end of the cable should be
connected to the source reference point. See figure 3.2.