Rockwell Automation 61C346 4 Input 0-10V Analog Rail Module - Manual (Page 13)

2Ć3
The faceplate of the module contains three electrical connectors
labeled Input", Analog I/O", and Input Power" (reading top to
bottom). The top connector is used for connection to the I/O port. A
cable (M/N 45C5) is provided for this purpose. The second
connector, labeled Analog I/O", is a numbered, 12Ćpoint removable
plug connector with screwĆtype terminal points. Three successive
terminal points are reserved for each channel's connection to
external hardware. The Analog Inputs" terminals are designed for
14Ć22 AWG wire.
The third connector on the faceplate, also a removable plug
connector with screwĆtype terminal points, is used for input power.
The terminal points are labeled. The top two points are used if the
power source is 24 VDC. The bottom two points are used if the power
source is 120 VAC. The Input Power" terminals are designed to use
14 AWG wire. A terminal stud for connecting a grounding conductor
is provided on the bottom of the rightĆhand mounting flange.
The module faceplate also contains two LEDs, a mode switch, and a
fuse holder and fuse. The LED labeled PWR OK" indicates that the
I/O port, the external power source, and the internallyĆgenerated
voltages necessary for operation of the module are present. The
COM OK" LED indicates whether all four channels are successfully
communicating with the host.
The switch labeled Mode" is used to select between Local Head"
and Rail" mode. Note that the position of the switch is read only
once at the time power is turned on to the Reliance device that is
connected to the Analog Rail module. The mode will remain fixed as
long as this device is powered up.
As shipped from the factory, the fuse holder on the bottom of the
faceplate contains a .25A fuse for 120 VAC input power. If input
power will be 24 VDC, you need to replace the fuse with the .75A
fuse included along with the Analog Rail module.