Rockwell Automation 61C346 4 Input 0-10V Analog Rail Module - Manual (Page 16)

3Ć2
3.2 Initial Installation
Use the following procedure to install the Analog Rail module.
Step 1.
Using the mounting dimensions shown in figure 3.1,
prepare the necessary mounting provisions on the panel.
The module is designed to be mounted vertically using
four #10 or M5 bolts or studs. Multiple modules should be
mounted side by side. The flange width of two modules
side by side is sufficient to dissipate the heat produced by
the modules. The modules can also be mounted one
above the other, but since this hardware configuration
does not allow the most efficient heat dissipation, the
minimum clearance between the module chassis is 3".
See figure 3.1.
Depth: 7.75"
Diameter of mounting holes: 7/32"
7.0"
2.44"
3.0"
2.94"
9.25"
Figure 3.1 ĆMounting Dimensions