Rockwell Automation 1757-FFLD Linking Device Configuration Manual - Manual (Page 73)

Publication 1757-PM002A-EN-E - June 2006
Applications 4-19
4. Click OK.
A blue line is added to the AI block to represent the incomplete link.
5. Click the LGX Block to complete the link.
Hold to draw straight lines.
The Input Parameter Selection window opens.
6. Select the IN_0 pin and click OK.
A link is drawn from the AI block to the LGX block.
7. Click the LGX block again.
8. Select the OUT_0 pin and click OK.
9. Click the AO block to complete the Link.
10. Select the CAS_IN pin and click OK.
A link is drawn from the PID block to the AO block.
11. Click the Link button and select the AO block again.
12. Select the BKCAL_OUT pin and click OK.
13. Click below the block, move the cursor under the Logix block, and click
again.
A segmented line is drawn.
14. Click the LGX block to complete the Link.