Rockwell Automation 1756-IH16ISOE ControlLogix Sequence of Events Module - Manual (Page 31)

Publication 1756-UM528A-EN-P - April 2004
Installing the Sequence of Events Module 3-5
Spring Clamp RTB
1. Strip 7/16 inch (11mm) maximum length of wire.
2. Insert the screwdriver into the inner hole of the RTB.
3. Insert the wire into the open terminal and remove the
screwdriver.
Figure 3.6
Recommendations for Wiring Your RTB
Consider the following guidelines when wiring your RTB:
• Begin wiring the RTB at the bottom terminals and move up.
• Use a tie to secure the wires in the strain relief area of the
RTB.
• The jumper bar part number is 97739201. Contact your local
Rockwell Automation sales representative to order additional
jumper bars, if necessary.
• Order and use an extended-depth housing (Catalog
number 1756-TBE) for applications that require heavy gauge
wiring. For more information, see page 3-8.
20860-M
Strain relief area