Rockwell Automation 1747-KE,D17476.12 DH-485/RS-232C Interface Module - Manual (Page 53)

Publication 1747-UM005B-EN-P - March 2006
Installation and System Configuration 4-15
Configure Your Module Configuration instructions are in Chapter 5, Module Configuration
Using an ASCII Terminal, and Chapter 6, Module Configuration Using
the Backplane.
Proceed to the chapter that corresponds to the configuration method
you have chosen.
Complete the Installation of
Your Module Once your interface module has been configured, complete the
module’s installation.
1. If you configured your module using an ASCII terminal, place
the module into Run mode.
a. Remove the module from the chassis.
The removal is reverse of the installation directions found on
page 4-7.
b. Place your module in Run mode using JW4
ATTENTION
This module is a device used for communications.
Improper configuration or module failure may cause
communications to stop. Be careful to avoid system
designs that would cause probable safety concerns
within the system in the event of a communication
failure.
ATTENTION
Do not install or remove the 1747-KE module from
the SLC 500 chassis until all power dissipates from
the SLC 500 power supply (approximately 10
seconds).
Series A Functionality
(mod. config. ID=4209) Series B Functionality
(mod. config. ID=3509)
Horizontal Run
Mode
Vertical Run
Mode