Rockwell Automation 1756-IF4FXOF2F ControlLogix High-speed Analog I/O Module - Manual (Page 90)

90 Rockwell Automation Publication 1756-UM005B-EN-P - January 2013
Chapter 6 Calibrate the Module
6. Apply the calibrator’s high reference to the module.
The following example shows the channel status after calibrating for a high
reference. If the channels is OK, continue, as shown below. If any channels
report an Error, retry until the status is OK.
The following parameters appear next and define the status of the low and
high calibration.
Calibrate Output Channels Output calibration requires that you command the output channels to produce
specific voltage or current levels and then measure the signal to verify that the
module is working properly. This process involves these tasks:
• Command the channel (or group of channels) to produce a low reference
signal.
• Verify and record the channel’s output.
• Command the channel (or group of channels) to produce a high reference
signal.
• Verify and record the channel’s output.
Click Next to calibrate the high reference.
Click Finish to complete calibration for the channel.