2 - quick start guide, Required tools and equipment, Chapter 2 – Rockwell Automation 1746-NR4 SLC RTD/Resistance Input Module User Manual User Manual
Page 23: Quick start guide, Chapter

23
Publication 1746-UM008B-EN-P - December 2006
Chapter
2
Quick Start Guide
This chapter helps you get started using the RTD module. The
procedures included here assume that you have a basic understanding
of SLC 500 products.
You must:
• understand electronic process control.
• be able to interpret the ladder logic instructions for generating
the electronic signals that control your application.
Because this is a start-up guide, this chapter does not contain detailed
explanations about the procedures listed. It does, however, reference
other chapters in this book where you can get more detailed
information.
If you have any questions or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the
referenced chapters and other recommended documentation before
trying to apply the information.
This chapter:
• tells you what equipment you need.
• explains how to install and wire the module.
• shows you how to set up one channel for RTD or resistance
input.
• examines the state of the LED indicators at normal startup.
• examines the channel status word.
Required Tools and
Equipment
Have the following tools and equipment ready.
• Medium blade screwdriver
• Medium cross-head screwdriver
• RTD module (1746-NR4)
• RTD sensor or resistance input
• Appropriate cable (if needed)
• Programming software