Rockwell Automation 1746-NR4 SLC RTD/Resistance Input Module User Manual User Manual

Slc 500 rtd/resistance input module

Table of contents

Document Outline

1746-UM008B-EN-P, SLC 500 RTD/Resistance Input Module User Manual
Important User Information
Summary of Changes
- New Information
Table of Contents
Preface
- Use This Manual
- Who Should Use This Manual
- Purpose of This Manual
- Common Techniques Used in This Manual
1 - Overview
- Description
- System Overview
2 - Quick Start Guide
- Required Tools and Equipment
- Procedures
3 - Install and Wire the Module
- EMC Directive
- Electrostatic Damage
- NR4 Power Requirements
- Module Location in Chassis
- Module Installation and Removal
- Terminal Wiring
- Calibration
4 - Preliminary Operating Considerations
- Module ID Code
- Module Addressing
- Channel Filter Frequency Selection
- Scanning Process and Channel Timing
- Channel Turn-on, Turn-off, and Reconfiguration Time
- Response to Slot Disabling
5 - Channel Configuration, Data, and Status
- Channel Configuration
- Channel Configuration Procedure
- Channel Data Word
- Channel Status Checking
6 - Ladder Programming Examples
- Device Configuration
- Initial Programming
- Dynamic Programming
- Verify Channel Configuration Changes
- Interface to the PID Instruction
- Use the Proportional Counts Data Format with User-set Scaling
- Monitor Channel Status Bits
- Invoke Autocalibration
7 - Module Diagnostics and Troubleshooting
- Introduction
- Module Operation vs. Channel Operation
- Power Turn-on Diagnostics
- Channel Diagnostics
- LED Indicators
- Error Codes
- Replacement Parts
- Contact Rockwell Automation
8 - Application Examples
- Basic Example
- Supplementary Example
A - Specifications
- Module Accuracy
B - RTD Standards
C - Configuration Worksheet for RTD/Resistance Module
- Channel Configuration Procedure
D - I/O Configuration
Glossary
Index
- A
- B
- C
- D
- E
- F
- G
- H
- I
- L
- M
- N
- O
- P
- R
- S
- T
- U
- W
Back Cover