Rockwell Automation 1784-PCD DeviceNet Communication Card - Manual (Page 45)

Install and Use the Driver for Windows NT 5-3
Publication 1784-IN029C-EN-P - June 2001
SystemSoft’s CardWizard
If you have SystemSoft’s CardWizard plug-and-play software, you must upgrade it
to version 4.0 or later. In addition, you will be able to use the A-B 1784-PCD card
Control Panel to assign memory and interrupt resources for the card.
For more information on obtaining the CardWizard upgrade for use with the
1784-PCD card, contact SystemSoft:
•
Internet: www.systemsoft.com
•
Phone: 1.800.796.0088 or 508.651.0088 (ask for sales)
Phoenix/Softex’s Card Executive
If you have Phoenix/Softex’s Card Executive plug-and-play software, you must
upgrade to version 2.21 or later.
Do not use the Allen-Bradley 1784-PCD card icon in the Control Panel to assign
memory and interrupt resources. The Phoenix/Softex PC card controller software
assigns these resources for you automatically.
For more information, contact Phoenix/Softex:
•
Internet: www.softexinc.com
•
Phone: 512.452.8836
•
Fax: 512.795.8702
TIP
Whenever you upgrade third-party plug-and-play software,
you must also upgrade all associated power management and
docking service software, if loaded, to the same version to
which you have upgraded the plug-and-play software.
IMPORTANT
You cannot use a series A 1784-PCD card with SystemSoft’s
CardWizard. Attempting to use the series A card may cause
your computer to lock up. If your computer locks up, remove
the series A card from your computer and reboot it.
IMPORTANT
You cannot configure and use 2 PCD cards at the same time
with SystemSoft’s CardWizard.