Rockwell Automation 1503 OEM Starter Frame Components Installation Manual - Manual (Page 5)

Chapter
1
OEM Starter Frame Installation
Read this document before performing any installation
procedures or adjustments. Observe all applicable
safety procedures when working on the equipment.
Complete all installation procedures before connecting
the incoming line cable. Failure to do so may result in
damage to the equipment or injury to personnel.
Receiving
Refer to General Handling Procedures for Medium Voltage Controllers
– Publication MV-QS050_-EN-P. This document is included with your
shipment and contains information regarding receiving, unpacking, initial
inspection, handling, storage, opening the medium voltage doors, and site
preparation.
Note: Refer to Appendix A for a listing of the items that are included in
your OEM Frame Kit.
Installation Standards and Codes
The OEM starter frame consists of a fusible non-load-break
isolation switch, an isolation switch handle, a vacuum contactor, control
circuitry and a medium voltage door. These components are not a complete
motor controller. The user must add appropriate control circuitry for the
application, power fusing, current transformer, control power transformer,
overload protection and a suitable enclosure. It is recommended that the
user be familiar with the following safety and design standards and codes,
and any additional local codes that a medium voltage starter must comply with.
• CEC (Canadian Electrical Code)
• CSA 22.2 No. 14 (Canadian Standards Association) – Industrial Control
Equipment
• NEC (National Electrical Code)
• NEMA ICS Standards (National Electrical Manufacutrers’ Association)
• OSHA (Occupational Safety and Health Administration)
• UL 50 (Underwriters Laboratories) – Enclosures for Electrical Equipment
• UL 347 (Underwriters Laboratories) – High voltage Industrial Control
Equipment
• UL 508 (Underwriters Laboratories) – Industrial Control Equipment
• IEC 60204-1 – Safety of Machinery – Electrical Equipment of Machines,
Part 1: General Requirements
• IEC 62271-200 – AC Metal Enclosed Switchgear and Control Gear for
Rated Voltages Above 1kV and up to 52 kV
• IEC 60470 – High Voltage Alternating Current Contactors
• IEC 60529 – Degrees of Protection Provided by Enclosures (IP Code)
• IEC 62271-1 – Common Clauses for High voltage Switchgear and
Control Gear Standards
1503-IN050E-EN-P – June 2013
A T T E N T I O N A T T E N T I O N
I M P O R T A N T I M P O R T A N T