Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay - Manual (Page 71)

6 Chapter Serial Communication
6-1
COMMUNICATIONS USING BULLETIN 1203
COMMUNICATION MODULES
The SMP-3 overload relay can communicate its parameter data
to a PLC, SLC, or other logic controller by using an optional
Bulletin 1203 communications module. The amount of
information that is transferred between the SMP-3 overload
relay and the logic controller is determined by the DIP switch
settings on the communication module.
The suggested DIP switch settings for an SMP-3 overload relay
and 1203-GD1 (used to communicate with a PLC) application
is shown in Table 6.A. DIP switch settings for other
communications modules will be similar. Refer to the
appropriate communication module user manual for details.
Table 6.A 1203-GD1 Communication Module Configuration (when
used with SMP-3 overload relay)
SW3
DIP #
Type of Data Transferred
Rack
Space
(in words)
Recom-
mended
Setting
Reference
Information
1
Block transfer of data
(not recommended)
1 off
2
Logic Control and SMP-3
overload relay Status data
1 on
See
Table 6.B
and 6.C
3 Analog reference 1 on
4
Parameter data via
Datalink A (not supported)
2 off
5
Parameter data via
Datalink B (not supported)
2 off
6
Parameter data via
Datalink C (not supported)
2 off
7
Parameter data via
Datalink D (not supported)
2 off
8 Unused — off