Basting -19 – Brother ULT2002D User Manual
Page 92
Sewing Utility Stitches
3-19
6
1
Basting
1. Select
.
2. Attach presser foot “J”. Press the “Reverse/ Reinforce-
ment Stitch” button to sew reinforcement stitches, then
continue sewing.
Note
• If you do not want to use a reinforcement stitch at the
beginning, you should lift the presser foot, rotate the
balance wheel, pull up the bobbin thread and pull a
length of top and bobbin thread out from the rear of
the machine.
• You can set the stitch length between 5 mm (3/16 inch)
and 30 mm (1-3/16 inch)
1 Between 5mm (3/16 inch) and 30 mm (1-3/16 inch)
3. Sew while keeping the fabric pulled tight.
4. End the basting with reinforcement stitches.
This manual is related to the following products: