Setting the bobbin -31, P.1-31), Caution – Brother ULT2002D User Manual
Page 42
Setting Up
1-31
1
2
1
1
Setting the Bobbin
Press
➜
➜
➜
in that order to display a video example of the
operation on the LCD (see page 1-21). Follow the steps explained below to complete the operation.
CAUTION
Setting the bobbin improperly may cause the thread tension
to loosen, breaking the needle and resulting in injury.
1 Wound evenly
2 Wound poorly
1. Raise the presser foot lever.
2. Slide the bobbin cover latch to the right, and remove
the bobbin cover.
1 Bobbin cover
3. Put the bobbin in the shuttle, making sure the thread
unrolls as shown.
CAUTION
Be sure the bobbin is set so the thread unrolls in
the correct direction. If the thread unrolls in the
wrong direction, it may cause the thread tension
to be incorrect or the needle to break.
4. Guide the thread through the groove, then pull the
thread toward you to cut off any excess.
1 Cutter
5. Replace the bobbin cover. Place the left tab in place
(see arrow 1 at left), then press lightly on the right side
(see arrow 2 at left) until the cover clicks into place.
Note
You can begin sewing without pulling up the bobbin
thread.
When you need to pull up the bobbin thread (free motion
embroidery) see the illustrated directions on page 1-38.