Ce conformity, Low voltage directive (2006/95/ec), Emc directive (2004/108/ec) – Rockwell Automation 23P PowerFlex DC Stand Alone Regulator and Gate Amplifier User Manual
Page 16: General considerations
16
Rockwell Automation Publication 23P-UM001D-EN-P - July 2012
Chapter 2 Stand Alone Regulator Installation, Wiring and Configuration
CE Conformity
Conformity with the Low Voltage Directive and Electromagnetic Compatibility
Directive has been demonstrated using harmonized European Norm (EN)
standards published in the Official Journal of the European Communities. The
PowerFlex DC Stand Alone Regulator complies with the EN standards listed
when installed according to this User Manual.
CE Declarations of Conformity are available online at:
Low Voltage Directive (2006/95/EC)
• EN 50178 Electronic equipment for use in power installations.
EMC Directive (2004/108/EC)
• EN 61800-3 Adjustable speed electrical power drive systems Part 3: EMC
product standard including specific test methods.
General Considerations
• For CE compliance, the SAR installation must satisfy requirements related
to both EN 50178 and EN 61800-3 provided in this document.
• The SAR complies with the EMC requirements of EN 61800-3 when
installed according to good EMC practices and the instructions provided
in this document. However, many factors can influence the EMC
compliance of an entire machine or installation, and compliance of the
SAR itself does not necessarily ensure compliance of all applications.
• The SAR is not intended to be used on public supply networks which
supply domestic premises. Without additional mitigation, radio frequency
interference is expected if used on such a network. The installer is
responsible to take measures such as supplementary line filters and
enclosures to prevent interference, in addition to the installation
requirements of this document.
Installation Requirements Related to EN 50178 and the Low
Voltage Directive
• The SAR is compliant with the CE LV Directive when used at altitudes no
greater than 2000 m (6562 ft).
• The SAR provided in enclosure type IP20 must be installed in a pollution
degree 1 or 2 environment to be compliant with the CE LV Directive.
Characteristics of the different pollution degree ratings are provided in
.