Remote access – Western Digital WD ShareSpace User Manual User Manual
Page 110
NETWORK STORAGE MANAGER: BASICS - 105
WD SHARESPACE
USER MANUAL
Remote Access
WD ShareSpace comes with MioNet enabled by default. The Remote Access
button on the Network tab home page enables you to control the MioNet service on
the storage device. If MioNet is not already set up through the web, follow the
instructions in “MioNet Remote Access” on page 55.
MioNet Icons
•
Start/Stop MioNet - Shows Stop MioNet if MioNet is running; shows Start Mionet
if MioNet is stopped.
•
Restart MioNet - Reboots MioNet.
•
Reset MioNet - Resets the MioNet account information on the WD ShareSpace.
If the WD ShareSpace is registered to a MioNet account, that registration is
erased so that the unit is now unregistered. This status is displayed in the upper
right corner of the page. Any shares created by MioNet or MioNet users remain,
and no data is lost. Access to these shares over the LAN requires the use of the
MioNet username and password.
MioNet Service Status Messages
•
MioNet service connection status
•
Started - MioNet service is started
•
Stopped - MioNet service is stopped and will start on system restart.
•
Disabled - MioNet service is disabled and will not start on system restart.
•
MioNet registration status
•
Unregistered - Not currently registered to a MioNet account
•
Registered - Already registered to a MioNet account
Note: A mouse-over of the registration status shows the MioNet account name if the device is
registered. To register with MioNet, go