Western Digital My Book World Edition (white light) User Manual - Manual (Page 15)

OVERVIEW - 9
MY BOOK WORLD EDITION
USER MANUAL
Power Button
Important: The device powers on automatically upon initial connection to
power, which may take up to three minutes. During this time, do not press
the power button. After the initial setup, you need to use the power button
to turn the unit on and off.
The power button turns the device on or off. To turn on the device, press the power
button and hold it down until the bottom LED illuminates, and then release. Holding
the button down for four seconds powers off the device.
When power is applied to the unit by plugging in the external power supply
connected to the DC plug connector, the unit automatically powers up. This ensures
the unit will automatically restart after a power failure.
If you power down a My Book World Edition by pressing the power button, and
disconnect and then reconnect the power plug, the unit powers up for about 30
seconds and then powers itself down. This ensures that the unit will not turn on
accidently and remain on if there is a power failure. You need to press the power
button to turn the unit on.
Kensington Security Slot
For drive security, the device is equipped with a security slot, which supports a
standard Kensington security cable. For more information on the Kensington security
slot and available products, visit www.kensington.com.