Setting function 2.6, 5 x n x – Waldmann PULSE PIR version IV - with MFT, Typ II User Manual
Page 29

29
Operating Manual Light Control „PULSE HFMD / PULSE PIR - Vers. IV“
ENG
Loading setting level 2
Actuation
Display
Light bar LED 1 (dark green)
Parameterisation mode ON
Function 2.6
Parameter setting protection
Light bar LED 6 (dark red)
Function 2.6
Changing the function from ON to OFF or vice versa
Setting function 2.6
LED changes from constantly lit
to flashing or vice versa:
- constant = Function ON
- flashing
= Function OFF
Press key II 5 times
Loading the parameterisation mode
Light bar LEDs 1+2
Level 2
Press both keys again
for 5 seconds
Press both keys
for at least 10 seconds
5 x
n x
Press key I as often as
necessary for reaching
the desired value
Parameter setting protection
Function for activating the param-
eter setting protection (required for
final inspection)
By default, the function is set to
"OFF".
When the function is switched on,
a factory reset will not overwrite
the set parameters. The parameter
setting of the electronic ballast
units will be carried out.
The function can be changed on
- Lights equipped with HFMD
sensor
- Lights equipped with PIR sensor