Waldmann PULSE PIR version IV - with MFT, Typ II - Manual (Page 19)

19
Operating Manual Light Control „PULSE HFMD / PULSE PIR - Vers. IV“ ENG
Loading setting level 1
Actuation Display
Light bar LED 1 (dark green)
Parameterisation mode ON
Function 1.4 Write protection
Light bar LED 4 (orange)
Function 1.4
Changing the function from ON to OFF or vice versa
Setting function 1.4
LED changes from constantly lit
to flashing or vice versa:
- constant = Function ON
- flashing = Function OFF
Press key II 3 times
Loading the parameterisation mode
Release both keys
Light bar LED 1 (dark green)
Level 1
Write protection
Function for allowing or preventing
setting changes.
By default, the function is set to
"OFF", i.e., set levels can always
be overwritten.
The levels cannot be changed if the
write protection is active.
The function can be changed on
- Lights equipped with HFMD
sensor
- Lights equipped with PIR sensor
Press both keys
for at least 10 seconds
3 x
n x Press key I as often as
necessary for reaching
the desired value