Waldmann PULSE PIR version IV - with MFT, Typ II - Manual (Page 28)

28
Operating Manual Light Control „PULSE HFMD / PULSE PIR - Vers. IV“ ENG
Loading setting level 2
Actuation Display
Light bar LED 1 (dark green)
Parameterisation mode ON
Function 2.5 Continuous mode
Light bar LED 5 (light red)
Function 2.5
Changing the function from ON to OFF or vice versa
Setting function 2.5
LED changes from constantly lit
to flashing or vice versa:
- constant = Function ON
- flashing = Function OFF
Loading the parameterisation mode
Press both keys again
for 5 seconds
Light bar LEDs 1+2
Level 2
Press key II 4 times
Continuous operation
Function for setting the light to
continuous mode.
By default, the function is set to
"OFF".
When the function is switched
on, the light will work in continu-
ous mode. Even if no presence is
detected, the light will be lit at the
lowest level.
The function can be changed on
- Lights equipped with HFMD
sensor
- Lights equipped with PIR sensor
Press both keys
for at least 10 seconds
4 x
n x
Press key I as often as
necessary for reaching
the desired value