Therma-Tru SHOP 3 Door Preparation - Book Size - Manual (Page 30)

Door
Preparation
3.30 2014 (BOOK SIZE) Shop 3
Multipoint Lock Preparation
(Except Fire & Steel Doors)
Tools Required:
Eurogroove router
(Provided in door kit)
Eurogroove Stops
Power Tool Notes:
Remember to always follow the safety and operation instructions of the equipment
manufacturers
Using the information provided below, determine the distance from each end that the Eurogroove
should stop.
For lengths less than 5”, the wing nut is removed from the two piece jig, which is then clamped to
the top surface of the sidelite. The two adjustable nuts are then used for the stop locations.
For lengths greater than 5”, place the pin with the wing nut in the hole that corresponds with the
desired distance. The one piece jig is then clamped to the lock side of the sidelite.
Place the router on the sidelite stile with the bit extending into the hole machined in Step 1.
Then machine the Eurogroove, stopping the router when the base plate hits each stop
Step 2 - Sidelite Eurogroove Machining
UNIT
SIZE
BOTTOM
STOP
UNIT
SIZE
TOP
STOP
6/6
6/8
8/0 12.562”
15.110”
15.110” 2.394”
2.394”
15.402”