Therma-Tru Doors Installation - Manual (Page 72)

Installation
1.72 2014 SITE 1
Screen Installation
Remove existing screen track by rotating the back edge
down as you pry it out.
Insert wheels of top hung adapter into top hung track as
shown.
Position track up into screen channel. Drill 1/16” pilot holes
or punch with an awl, thru holes in track into head jamb
approximately 1/4” deep.
Insert screen into adapter channel and rotate down
engaging wheels in bottom of screen with track on sill.
Fasten track to head jamb with #4 x 1/2” flat head screws.
Align adapter with edge of screen.
Drill 1/8” holes thru hole locations in adapter into screen
from exterior of unit.
Fasten with #10 x 1/2” screws.
Doubles/Triples: Align with edge OPPOSITE of handle side.
Quads: Align with edge on handle side.
Close screen door and locate position of latch on side jamb.
Mark hole locations for latch. Drill 1/16” pilot holes.
Fasten with (2) #6 x 5/8” pan head screws.
1
6
7
8
9
2
3
5
4
Quad Systems Only
#10 x 1/2”
pan head screw
#4 x 1/2”
pan head screw
#6 x 5/8”
pan head screw
Adapter Track Latch
Screen
Active Passive
#8 x 1” pan head screw
Position screen astragal on passive screen so it does not
interfere with head and sill tracks. Pre-drill (4) equally
spaced 1/8” pilot holes. Fasten astragal to screen with
(4) #8 x 1” pan head screws.
“Wide Profile” Screen Installation - Sliding Patio