Therma-Tru Doors Installation - Manual (Page 57)

Installation
SITE 1 2014 1.57
Adjusta-Fit 2
Prehanging Instructions
JOB SITE COMPONENTS
TRIM (3 Pieces)
Hinge, Lock and
Head Trim
(2) #8 x 3/4” Phillips Flat Head Wood Screw
(2) #8 x 1 1/4” Phillips Flat Head Wood Screw
(6) #10 x 2 1/2” Phillips Flat Head Wood Screw
(2) #12-24 x 1/2” Phillips
Undercut Flat Head
Type A Machine Screw
(2) #8-32 x 3/8” Phillips
Undercut Flat Head
Type F Self-tapping
Machine Screw
HARDWARE
SILL EXTENDER
(included in inswing package only)
FULL LIP STRIKE
CONVERTER PLATE
DEADBOLT
LOCK PLATE
DEADBOLT COVER
PLATE (door)
(2) DEADBOLT
FILLER (door)
(2) CORNER
SEAL PAD
INSTALLATION INSTRUCTIONS
PURCHASED SEPARATELY
PAINTING FRAME AND DOOR
• DOOR PREP: Brush or sponge off dirt. Wipe dry.
• Use a high quality exterior house paint to finish the
frame and door when the temperature is above 50°F
and humidity is below 90%.
• DO NOT paint weatherstrip. (It can be temporarily
• DO NOT close door until the paint is completely dry.
• FRAME PREP: Wet-clean with mild abrasive cleaner.
TOOLS REQUIRED
• Drill with #2 Phillips Driver Bit
• Shims
• Caulk Gun and Exterior Grade Sealant
• Utility knife or Scissors
• Category “G” Edge Seal
• Face attachment screws
• #8 x 1 1/4” flat head masonry screws for
masonry installations
For information on where to purchase
Therma-Tru entry door systems,
call 1-800-THERMA-TRU (843-7628)
or visit www.thermatru.com
• Paint the door in an open position.
removed for painting.)
Rinse completely and wipe dry.
Adjusta-Fit ® 2
Parts List and Description